INSTALLATION AND OPERATING INSTRUCTIONSCyclone SERIES GAS CONVECTION OVENSModels: BCO-G and GDCO-GINTENDED FOR OTHER THAN HOUSEHOLD USE. RETAIN TH
BLACKP1P2P3P4COMNCNOT6T7 T8T9 T10T11BLUEYELLOWGROUND STUDPOWERLIGHTT-STATLIGHTSWITCHLIGHTS60 MINTIMERPOWERSWITCHDOOR SWITCHFLAME SENSORIGNITERHIGHLOWC
WIRING DIAGRAM - BCO-G & GDCO-G 240V, 1 PHASE (DIAL CONTROL)WIRING DIAGRAM - GDCO-G 240V, 1 PHASE (PUSH-BUTTON CONTROL)1188066588806660BLACKP1
12PROBLEM CAUSE SOLUTIONFood browns unevenly Improper heating temperature.Preheat until desired temperature is reached.Several pans crowded together
PARTS LISTModel Number: BCO-G & GDCO-G Type of Gas: Natural L.P. Other
Exterior / Interior / Controls / Doors 4/05
Item Part # Description Quan Item Part # Description
16 WHAT IS COVERED This warranty covers defects in material and workmanship under normal use, and applies only to the original purchaser providing tha
I. INSTALLATION INSTRUCTIONS Section Item PageA Receiving 2B Set Up / Mounting 2C Installation with Casters (Optional) 3D Location &a
3For a single unit: Refer to Figure 4(1) Tilt Oven over to left-hand side and attach two 31” legs on the right-hand side with three ½” bolts and washe
D. LOCATION AND MINIMUM CLEARANCES:Move the oven to its final location keeping the minimum clearance from the back of the oven to the wall. This clea
F. ELECTRICAL CONNECTION:The oven, when installed, must be electrically grounded in accordance with local codes and/or the latest edition of the Nat
(4) Press Oven Light switch. Oven light will go on and will go off when switch is released.(5) Turn Gas Cock Dial to “ON” position (only for USA and C
(6) Turn the timer knob to the desired bake time and timer will start counting down.(7) When timer reaches zero, a buzzer will sound.(8) Turn the time
8Clean The Stainless Steel Interior:Baked on splatter, oil, grease or discoloration on the stainless steel inside of the oven may be removed with stai
9MotorBlower WheelSet Screw (2)Wheel Puller Bolt 3/8” HexItem 1Item 2Item 3E3770AE3771A3/8”-16 Bolt1. Attach two item 2 to two item 1 using item
Comments to this Manuals