Bakers-pride BPCV-2-2W Manual User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
3
GENERAL
1. A manual gas shut-off valve must be installed in the gas supply (service) line ahead of the appliance
and gas pressure regulator for safety and ease in servicing.
2. The gas pressure regulator supplied must be installed on the appliance prior to connecting the
equipment to the gas line. Failure to install a regulator could be potentially hazardous and will void
the appliance warranty.
3. The appliance and its individual shut off valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of ½ psi (3.45kpa).
4. The appliance must be Isolated from gas supply piping system, by closing its individual manual shut
off valve during any pressure testing of the gas supply piping system at test pressures equal to or
less than ½ psi (3.45kpa).
5. To perform maintenance and repairs of the appliance, please contact the factory, the factory
representative, or the nearest authorized local service company.
OPERATING INSTRUCTIONS
RATING PLATE
The rating plate is located in front of the range below the oven section. Information on this plate
includes the model, serial number, BTU / hour input of the burners, operating gas pressure in inches
WC, and whether the appliance is orificed for natural or propane gas. Pilot lighting instructions (ovens
only) are also located in the same area.
BAKERS PRIDE COOKING APPLIANCES MUST BE CONNECTED ONLY TO THE
TYPE OF GAS IDENTIFIED ON THE RATING PLATE
CLEARANCES
The appliance area must be kept free and clear of all combustibles.
This unit is design-certified for the
following installations only:
The clearances from combustible and non combustible construction are as follows:
Combustible Non combustible
Back
6
"
0
Sides
6
"
0
DO NOT MOUNT oven on a curb base. Use legs/casters provided. Adequate air space at the bottom
and rear of the unit must be provided for proper venting of blower motor.
ASSEMBLY
DO NOT USE door to lift or move oven!!! All ovens must be installed on leg assembly or casters
shipped with the unit
The leg/stand assembly parts or casters are shipped separately.
Page view 2
1 2 3 4 5 6 7 8 ... 13 14

Comments to this Manuals

No comments